Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1035

Meaning
Copyright © 2010, Juniper Networks, Inc.
user@SWA-0> show virtual-chassis vc-port all-members
fpc0:
--------------------------------------------------------------------------
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
fpc1:
--------------------------------------------------------------------------
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
fpc2:
--------------------------------------------------------------------------
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
fpc3:
--------------------------------------------------------------------------
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
fpc4:
--------------------------------------------------------------------------
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
fpc5:
Interface Type
or
PIC / Port
vcp-0 Dedicated
vcp-1 Dedicated
The show virtual-chassis vc-port all-members
enabled for the member switches of the Virtual Chassis configuration and shows the
status of the interfaces. In this case, no VCP uplinks have been configured. However, the
VCP interfaces are automatically configured and enabled when you interconnect member
switches using the dedicated VCPs. There are two dedicated VCPs on the rear panel of
each EX4200 switch. The dedicated VCP interfaces are identified simply as vcp-0 and
vcp-1. They do not use the standard interface address (in which the member ID is
represented by the first digit). The output in this example shows that all interfaces are
operational. The fpc number is the same as the member ID.
Chapter 38: EX4200 Virtual Chassis—Configuration Examples
Status
Up
Up
Status
Up
Up
Status
Up
Up
Status
Up
Up
Status
Up
Up
Status
Up
Up
command lists the VCP interfaces that are
931