Configuring Chassis; Chapter 11 Configuring Chassis; Configuring Aggregated Devices (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

CHAPTER 11

Configuring Chassis

Configuring Aggregated Devices (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring Aggregated Devices (NSM Procedure) on page 97
Configuring Chassis Alarms (NSM Procedure) on page 98
Configuring Container Interfaces (NSM Procedure) on page 99
Configuring Chassis FPC (NSM Procedure) on page 100
Configuring a T640 Router on a Routing Matrix (NSM Procedure) on page 105
Configuring Routing Engine Redundancy (NSM Procedure) on page 110
Configuring a Routing Engine to Reboot or Halt on Hard Disk Errors (NSM
Procedure) on page 111
The JUNOS Software supports the aggregation of physical devices into the defined virtual
links, such as the link aggregation of Ethernet interfaces defined by the IEEE 802.3ad
standard. You can configure the properties for Ethernet and sonet aggregated devices
on the router.
To configure the aggregated devices on the router:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Aggregated
3.
Devices.
Add or modify the settings as specified in Table 45 on page 98.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
97