Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1054

Complete Software Guide for Junos
Purpose
Action
Meaning
Purpose
Action
950
®
OS for EX Series Ethernet Switches, Release 10.4
Verifying the LACP Settings
Verify that LACP has been set up correctly.
Use the
show lacp interfaces interface-name
enabled as active on one end.
user@Host-A> show lacp interfaces xe-0/1/0
Aggregated interface: ae0
LACP state: Role
xe-0/1/0 Actor
xe-0/1/0 Partner
LACP protocol: Receive State
xe-0/1/0
The output indicates that LACP has been set up correctly and is active at one end.
Verifying That the LACP Packets Are Being Exchanged
Verify that LACP packets are being exchanged.
Use the
show interfaces aex statistics
user@Host-A> show interfaces ae0 statistics
Physical interface: ae0, Enabled, Physical link is Down
Interface index: 153, SNMP ifIndex: 30
Link-level type: Ethernet, MTU: 1514, Speed: Unspecified, Loopback: Disabled,
Source filtering: Disabled, Flow control: Disabled, Minimum links needed: 1,
Minimum bandwidth needed: 0
Device flags : Present Running
Interface flags: Hardware-Down SNMP-Traps Internal: 0x0
Current address: 02:19:e2:50:45:e0, Hardware address: 02:19:e2:50:45:e0
Last flapped : Never
Statistics last cleared: Never
Input packets : 0
Output packets: 0
Input errors: 0, Output errors: 0
Logical interface ae0.0 (Index 71) (SNMP ifIndex 34)
Flags: Hardware-Down Device-Down SNMP-Traps Encapsulation: ENET2
Statistics Packets
Bundle:
Input :
Output:
Protocol inet
Flags: None
Addresses, Flags: Dest-route-down Is-Preferred Is-Primary
command to check that LACP has been
Exp Def Dist Col
No Yes No No
No Yes No No
Transmit State
Defaulted Fast periodic
command to display LACP information.
pps
0 0
0 0
Syn Aggr Timeout Activity
No Yes Fast Active
No Yes Fast Passive
Mux State
Detached
Bytes bps
0 0
0 0
Copyright © 2010, Juniper Networks, Inc.