CHAPTER 2
Configuring Chassis
Configuring Aggregated Devices (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
This section contains the following:
Configuring Aggregated Devices (NSM Procedure) on page 11
Configuring Chassis Alarms (NSM Procedure) on page 12
Configuring Routing Engine Redundancy (NSM Procedure) on page 13
The JUNOS Software supports the aggregation of physical devices into the defined virtual
links, such as the link aggregation of Ethernet interfaces defined by the IEEE 802.3ad
standard. You can configure the properties for Ethernet and sonet aggregated devices
on the router.
To configure the aggregated devices on the router:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Aggregated
3.
Devices.
Add or modify the settings as specified in Table 11 on page 12.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
11