Setting The Master/Slave Trigger - HBM GEN Series User Manual

2.2.5

Setting the Master/Slave trigger

When the Master/Slave board is in use, a recorder can either put the recorder trigger on the
Master/Slave trigger line and/or pick up the trigger from the Master/Slave trigger line.
There are four settings that can be selected in the Perception software:
Disabled
l
No trigger transmitted to or received from other mainframes
Transmit
l
Transmit trigger(s) from this recorder to other mainframes
Receive
l
Receive trigger(s) from other mainframes
Transceive
l
Transmit and receive trigger(s) from other mainframes
The settings are controlled in a block diagram or through the Master/Slave trigger setting in the
sheet.
Figure 2-18: Block diagram
28 I2710-1.0 en