Increasing The Maximum Configurable Value Of The Leaveall Timer; Enabling Gvrp; Disabling Vlan Advertising - HP 9304m Installation And Getting Started Manual

Installation and Getting Started Guide

Increasing the Maximum Configurable Value of the Leaveall Timer

By default, the highest value you can specify for the Leaveall timer is 300000 ms. You can increase the maximum
configurable value of the Leaveall timer to 1000000 ms.
NOTE: You must enter this command before enabling GVRP. Once GVRP is enabled, you cannot change the
maximum Leaveall timer value.
NOTE: This command does not change the default value of the Leaveall timer itself. The command only
changes the maximum value to which you can set the Leaveall timer.
To increase the maximum value you can specify for the Leaveall timer, enter a command such as the following at
the global CONFIG level of the CLI:
HP9300(config)# gvrp-max-leaveall-timer 1000000
Syntax: [no] gvrp-max-leaveall-timer <ms>
The <ms> parameter specifies the maximum number of ms to which you can set the Leaveall timer. You can
specify from 300000 – 1000000 (one million) ms. The value must be a multiple of 100 ms. The default is 300000
ms.

Enabling GVRP

To enable GVRP, enter commands such as the following at the global CONFIG level of the CLI:
HP9300(config)# gvrp-enable
HP9300(config-gvrp)# enable all
The first command globally enables support for the feature and changes the CLI to the GVRP configuration level.
The second command enables GVRP on all ports on the device.
The following command enables GVRP on ports 1/24, 6/24, and 8/17:
HP9300(config-gvrp)# enable ethernet 1/24 ethernet 6/24 ethernet 8/17
Syntax: [no] gvrp-enable
Syntax: [no] enable all | ethernet <portnum> [ethernet <portnum> | to <portnum>]
The all parameter enables GVRP on all ports.
The ethernet <portnum> [ethernet <portnum> | to <portnum>] parameter enables GVRP on the specified list or
range of Ethernet ports.
• To specify a list, enter each port as ethernet <portnum> followed by a space. For example, to enable GVRP
on three Ethernet ports, enter the following command: enable ethernet 1/24 ethernet 6/24 ethernet 8/17
• To specify a range, enter the first port in the range as ethernet <portnum> followed by to followed by the last
port in the range. For example, to add ports 1/1 – 1/8, enter the following command: enable ethernet 1/1 to
1/8
You can combine lists and ranges in the same command. For example: enable ethernet 1/1 to 1/8 ethernet 1/24
ethernet 6/24 ethernet 8/17

Disabling VLAN Advertising

To disable VLAN advertising on a port enabled for GVRP, enter a command such as the following at the GVRP
configuration level:
HP9300(config-gvrp)# block-applicant ethernet 1/24 ethernet 6/24 ethernet 8/17
This command disables advertising of VLAN information on ports 1/24, 6/24, and 8/17.
Syntax: [no] block-applicant all | ethernet <portnum> [ethernet <portnum> | to <portnum>]
8 - 6