Garp Timer Leaveall; Gvrp - HP 3100 v2 Series Command Reference Manual

<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] garp timer leave 100

garp timer leaveall

Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default level
2: System level
Parameters
timer-value: Leaveall timer (in centiseconds), which must be a multiple of 5 and range from the
maximum Leave timer on the device (exclusive) to 32765 (inclusive).
Description
Use garp timer leaveall to set the GARP LeaveAll timer.
Use undo garp timer leaveall to restore the default. This may fail if the default is beyond the valid
value range for the LeaveAll timer.
By default, the LeaveAll timer is 1000 centiseconds.
NOTE:
To keep the dynamic VLANs learned through GVRP stable, do not set the LeaveAll timer smaller
than its default value.
Related commands: display garp timer and garp timer leave.
Examples
# Set the leaveall timer to 2000 centiseconds, assuming that the Leave timer on every port is set to
60 centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 2000

gvrp

Syntax
gvrp
undo gvrp
View
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default level
2: System level
Parameters
None
178