Lacp Enable-Timer - HP Aruba JL253A Management And Configuration Manual

Example: eth-Trk
Parameters
value
Sets the threshold value for LACP trunk. The value is an integer that ranges from zero to eight which
represents the number of minimum active links. The default value is zero which disables the minimum active
links.
Example
Switch(eth-Trk11)# lacp
enable-timer
key
mad-passthrough
min-active-links
active
passive
static
Switch(eth-Trk11)# lacp min-active-links
<0-8>
Switch(eth-Trk11)# lacp min-active-links 5
WARNING: This configuration can result in disabling the trunk, if the
number of active links in the trunk drops below the configured threshold.
Continue (y/n)? y

lacp enable-timer

Syntax
lacp enable-timer <value>
no lacp enable-timer <value>
Description
Configures the timer on expiry of which the member links disabled by LACP min-active-links functionality,
will be re-enabled.
The no form of this command deletes the configured time and sets the time to default.
Command context
interface
Example: eth-Trk
Parameters
value
Sets the time duration to wait before enabling the disabled trunk. The time duration ranges from 0 to 604800
seconds. The default value is zero which disables the timer.
Example
Switch(eth-Trk11)# lacp
enable-timer
key
140
Configure the time in seconds to wait before re-enabling
the trunk disabled by LACP feature for minimum active links.
Set the LACP key.
Enable or disable MAD passthrough on the LACP trunks.
Configure the threshold for the minimum number of active
member links in a LACP trunk group, for it to be operational.
Enable active LACP.
Enable passive LACP.
Set the mode of a static LACP port to active or passive.
Enter a number.
Configure the time in seconds to wait before re-enabling
the trunk disabled by LACP feature for minimum active links.
Set the LACP key.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08