Garp Timer Leave; Garp Timer Leaveall - HP 6125G Command Reference Manual

garp timer leave

Syntax
garp timer leave timer-value
undo garp timer leave
View
Ethernet interface view, Layer-2 aggregate interface view
Default level
2: System level
Parameters
timer-value: Leave timer (in centiseconds), which must be a multiple of 5 and range from twice the Join
timer (exclusive) to the LeaveAll timer (exclusive).
Description
Use garp timer leave to set the GARP Leave timer for an Ethernet port or Layer-2 aggregate interface.
Use undo garp timer leave to restore the default of the GARP Leave timer. This may fail if the default is
beyond the valid value range for the Leave timer.
By default, the Leave timer is set to 60 centiseconds.
Related commands: display garp timer, garp timer join, and garp timer leaveall.
Examples
# Set the GARP Leave timer to 100 centiseconds, assuming that both the Join timer and the LeaveAll timer
are using the default.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] garp timer leave 100

garp timer leaveall

Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default level
2: System level
Parameters
timer-value: Leaveall timer (in centiseconds), which must be a multiple of 5 and range from the maximum
Leave timer on the device (exclusive) to 32765 (inclusive).
Description
Use garp timer leaveall to set the GARP LeaveAll timer.
190