Honda Accord 2008 Manual page 93

07/11/02 09:06:11 61TA0000_040_0047
Cruise Control
Cruise Control Input Test (cont'd)
Signal to be tested
Resume
switch signal
Cancel switch
signal
Cruise control
indicator
signal
4-46
Test condition Parameter: Desired result
Resume/accel switch CRUISE CONTROL
pressed and released RESUME SW should
indicate ON when the
resume/accel switch is
pressed and OFF when
the resume/accel
switch is released.
Cancel switch CRUISE CONTROL
pressed and released CANCEL SW should
indicate ON when the
cancel switch is
pressed and OFF when
the cancel switch is
released.
Start the engine, turn CRUISE INDICATOR
the cruise control should indicate ON
main switch on, and when the cruise control
drive the vehicle to is set and OFF when
speeds over 25 mph the cruise control is
(40 km/h). Set and canceled.
cancel the cruise
control.
Possible cause if result is not obtained
• Faulty cruise control combination switch
• An open in the wire between the gauge
control module and the cruise control
combination switch
• A wire shorted to ground between the
gauge control module and the cruise
control combination switch
Faulty cruise control combination switch
Faulty gauge control module