Front Vehicle Speed Sensor - Subaru IMPREZA 2002 Service Manual

FRONT VEHICLE SPEED SENSOR
I
AUTOMATIC TRANSM I SSl ON
13.Front Vehicle Speed Sensor
A: REMOVAL
1) Set up the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Remove the air cleaner case. (Non-turbo model)
<Ref. to IN(SOHC)-6, REMOVAL, Air Cleaner
Case.>
4) Remove the intercooler. (Turbo model) <Ref. to
W(DOHC TURBO)-1 0, REMOVAL, Intercooler.>
5) Disconnect the transmission connector.
(A)
Transmission connector
6) Remove the transmission connector from stay.
7) Lift-up the vehicle.
8) Clean the transmission exterior.
9) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 N-m (2.5 kgf-m, 18.1 ft-lb)
(A) Oil pan
(B) Drain plug
(C) Differential oil drain plug
IO) Remove the front, center, rear, exhaust pipes
and muffler.
<Ref. to EX(S0HC)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(S0HC)-9, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(S0HC)-1 1, RE-
MOVAL, Muffler.>
11) Remove the center, rear exhaust pipes and
muffler. (Turbo model) <Ref. to EX(D0HC TUR-
BO)-8, REMOVAL, Center Exhaust Pipe.>, <Ref.
to EX(D0HC TURBO)-13, REMOVAL, Rear Ex-
haust Pipe.>, <Ref. to EX(D0HC TURBO)-14, RE-
MOVAL, Muffler.>
12) Remove the shield cover.
13) Remove the propeller shaft. <Ref. to DS-14,
REMOVAL, Propeller Shaft.>
14) Place the transmission jack under crossmem-
ber.
NOTE:
Place a shop cloth or equivalent between the
crossmember and transmission.
15) Remove the transmission rear crossmember
bolts.
\
AT-32