Check Oil Level In Gear Box - Rotax 125 senior MAX evo Installation Manual

CHECK OIL LEVEL IN GEAR BOX

The gear box is already filled with the appropriate
amount of oil 100 CC (0.026 gal.) by the engine man-
ufacturer. However, before the engine is installed in
the frame, the oil level must be verified or
replenished.
Step Procedure
1
Place engine on a horizontal surface
and/or assembling trestle.
NOTE
To measure the oil level exactly, drain the gear
oil and determine it using a measuring cup.
Step Procedure
2 Loosen Allen screw (pos. 1) with gas-
ket ring (pos. 2) and absorb the leaking
oil in a measuring cup. If necessary,
remove the air vent screw (pos. 3) to
ensure a better oil drain.
3 Determine the gear oil using the meas-
uring cup.
NOTE
Oil capacity at new filling is 100 cc (0.026 gal).
NOTE
Specification of gear oil: engine oil SAE 15W-
40.
Procedure
Step
4
Tighten the Allen screw (pos. 1) with
new gasket ring (pos. 2) to 10 Nm.
5 Replenish new gear oil in the air vent
hole.
6 Hand-tighten the air vent screw (pos.
3).
7
Page 2
Edition: March 01 2021
BRP-Rotax
INSTALLATION INSTRUCTION
Figure 8.1
1 Allen screw
3 Air vent screw
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
2 Gasket ring