Leak Tests; Checking The Fuel Lines; Checking The Fuel Pressure Regulator - Rotax 912 i Series Maintenance Manual

LEAK TESTS

General note
Instruction To check the following steps are necessary:
Step

CHECKING THE FUEL LINES

General note
See
Instruction
Step

CHECKING THE FUEL PRESSURE REGULATOR

General note
Step
12–20–00
Page 30
September 01/2018
MAINTENANCE MANUAL LINE
Avoid over-tightening the fastening elements. Use a suitable torque wrench for
Procedure
1 Inspect all fuel lines, their connections and unions.
2 Inspect the fuel lines for sign of chafing.
Chapter 05–10–00 section Time limit for
Procedure
1 Inspect all hoses for porosity and other damage in particular at the hose
clamps and connections and replace as required.
2 Check fuel line (of steel).
Procedure
1 Check the fuel pressure regulator (1) for damages and inspect the general
condition.
2 Perform a leak test (Fuel pumps "ON").
3
Inspect all connections (2) for secure attachment.
BRP-Rotax
ATTENTION
all work.
parts.
Effectivity: 912 i Series
Edition 2/Rev. 0