Bridge - Allied Telesis AR2050V Command Reference Manual

B C
RIDGING OMMANDS

BRIDGE

bridge
Overview Use this command to create a software bridge.
Use the no variant of this command to remove the specified bridge.
Syntax bridge [<bridge-id>]
no bridge [<bridge-id>]
Default No configured bridges
Mode Global Configuration
Usage The bridge interface name will be prefixed with 'br' followed by the bridge ID.
If interfaces exist on a bridge, then the bridge cannot be removed. For example if
interface eth1 exists on bridge 2, then the no bridge 2 command will give you the
following message:
% failed to remove interface br2, there are still configured
sub-interfaces.
Example To create a bridge with the ID of 2, use the following commands:
awplus#configure terminal
awplus(config)#bridge 2
To remove the bridge with the ID of 2, use the following commands:
awplus#configure terminal
awplus(config)##no bridge 2
Related ageing-time
Commands
bridge-group
show bridge
show bridge macaddr
C613-50186-01 Rev B
Parameter Description
<bridge-id>
The bridge ID (from 1 to 64). This is made up of the bridge priority
and the bridge's MAC address.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
451