Mac-Filter-Group - Allied Telesis AR2050V Command Reference Manual

B C
RIDGING OMMANDS
- -
MAC FILTER GROUP

mac-filter-group

Overview This command applies a Layer two MAC filter on a bridge.
Use the no variant of this command to remove the mac-filter on a bridge.
Syntax mac-filter-group [<mac-filter-name>]
no mac-filter-group
Default None
Mode Interface Configuration
Usage You can only apply one MAC filter at one time.
Examples To apply a mac-filter with the name of ATL-router1 on bridge interface br1,use the
following commands:
awplus#configure terminal
awplus(config)#interface br1
awplus(config-if)#mac-filter-group ATL-router1
To remove the mac-filter on a bridge, use the following commands:
awplus#configure terminal
awplus(config)#interface br1
awplus(config-if)#no mac-filter-group
Output Figure 14-2: Example output from the mac-filter-group command displaying
Related clear mac-filter
Commands
mac-filter
show mac-filter
C613-50186-01 Rev B
Parameter
<mac-filter-name> The name of the mac-filter (maximum 16 characters).
information about all bridges:
mac-filter "ATL-router1" will be applied to the bridge interface
br1
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
456