Bridge-Group - Allied Telesis AR2050V Command Reference Manual

B C
RIDGING OMMANDS
-
BRIDGE GROUP

bridge-group

Overview Use this command to add an interface to a bridge.
Use the no variant of this command to remove an interface from a bridge.
Syntax bridge-group <1-64>
no bridge-group
Default An interface is not part of any bridge by default.
Mode Interface configuration.
Usage Interfaces can only be part of one bridge, so when removing the bridge no
parameters are required.
Interfaces that have been added to a bridge will lose their Layer 3 properties. The
bridge will act as the Layer 3 interface. The bridge will provide Layer 2 connectivity
between interfaces that are a part of the bridge.
You can only add eth, VLAN, OpenVPN (TAP only), and L2TPv3 ethernet pseudowire
interfaces to your bridge.
Examples To add eth1 to bridge 2, use the following commands:
awplus#configure terminal
awplus(config)#interface eth1
awplus(config-if)#bridge-group 2
To remove eth1 from your bridge, use the following commands:
awplus#configure terminal
awplus(config)#interface eth1
awplus(config-if)#bridge-group
Related ageing-time
Commands
bridge
show bridge
show bridge macaddr
C613-50186-01 Rev B
Parameter Description
<1-64> The ID of the bridge that you are adding the interface to.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
452