Spanning-Tree Link-Type - Allied Telesis AR2050V Command Reference Manual

S T C
PANNING REE OMMANDS
- -
SPANNING TREE LINK TYPE

spanning-tree link-type

Overview Use this command in Interface Configuration mode for a switch port interface only
to enable or disable point-to-point or shared link types on the switch port.
Use this command for RSTP or MSTP only.
Use the no variant of this command to return the port to the default link type.
spanning-tree link-type {point-to-point|shared}
Syntax
no spanning-tree link-type
Default The default link type is point-to-point.
Mode Interface Configuration mode for a switch port interface only.
Usage You may want to set link type to shared if the port is connected to a hub with
multiple devices connected to it.
awplus#
Examples
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter
shared
point-to-point
configure terminal
interface port1.0.2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Disable rapid transition.
Enable rapid transition.
spanning-tree link-type point-to-point
524