L3-Filtering Enable - Allied Telesis AR2050V Command Reference Manual

B C
RIDGING OMMANDS
3-
L FILTERING ENABLE

l3-filtering enable

Overview Use this command to enable traffic control for bridged traffic on a bridge interface.
Use the no variant of this command to disable traffic control for bridged traffic on
a bridge interface.
Syntax l3-filtering enable
no l3-filtering enable
Default Traffic control is disabled by default for bridged traffic.
Mode Interface mode for a bridge interface
Example To enable traffic control for bridged traffic on br1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related traffic-control
Commands
Command Version 5.4.7-0.1: command added. Previously, traffic control was enabled by
changes default on all bridge interfaces.
C613-50186-01 Rev B
configure terminal
interface br1
l3-filtering enable
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
454