Cluster Configuration Commands; Add-Member - Huawei Quidway S2000 Series Command Manual

Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches
[Quidway] ntdp timer port-delay 40

1.3 Cluster Configuration Commands

1.3.1 add-member

Syntax
add-member [member-num ] mac-address H-H-H [ password password ]
View
Cluster view
Parameter
member-num: Number of a member device, ranging from 1 to 256.
H-H-H: The hexadecimal MAC address of a member device.
password: The password of a candidate device. Before joining a cluster, the candidate
device should be authenticated. A candidate without password need not input
password. If password different from the password of the administrator device has
been configured on the candidate device, a user has to input that password before
adding the candidate device to the cluster.
Description
Using add-member command, you can add a candidate device to a cluster.
This command can be executed on the administrator device only. When adding a
cluster member, you can use the member-num parameter to assign a member number
to it at the same time. Remember to assign an unused number; otherwise, the system
will prompt error. If you do not specify the member number, the administrator device will
assign an unused one to the candidate.
A candidate with a password same as that of the administrator device or without
password can join the cluster free from password authentication. Otherwise, the user
has to input the password before adding the candidate.
Its device password will become the administrator device password if the candidate
device is added to the cluster system.
Chapter 1 HGMP V2 Configuration Commands
1-15