Configuring C-Rp; Configuring Static Rp - Huawei Quidway S6500 Series Operation Manual

Operation Manual - Multicast Protocol
Quidway S6500 Series Ethernet Switches
Table 6-10 Configuring C-BSR
Configure C-BSR
Remove C-BSR configuration
C-BSRs should be configured on the routers in the backbone network. By default, no
C-BSR is configured. The default value of the priority is 0.
Caution:
One router can only be configured with one candidate-BSR. When a new
candidate-BSR is configured on another interface, it will replace the previous one.

6.3.6 Configuring C-RP

In PIM-SM, a shared tree roots at an RP, with one or possibly many multicast groups
mapped to the RP.
Please perform the following configurations in PIM view.
Table 6-11 Configuring C-RP
Configure C-RP
Remove C-RP configiration
When configuring a C-RP, if the range of the served multicast groups is not specified, it
will serve all multicast groups. Otherwise, it will serve only those within the specified
range. It is suggested to configure C-RPs on routers over backbone network.

6.3.7 Configuring Static RP

A static RP can be the backup of a dynamic RP, to raise network robusticity.
Please perform the following configurations in PIM view.
Operation
Operation
Huawei Technologies Proprietary
c-bsr Vlan-interface
hash-mask-len [ priority ]
undo c-bsr
Command
c-rp Vlan-interface
[ group-policy
priority-value ]*
undo c-rp { Vlan-interface interface-number | all }
6-10
Chapter 6 PIM Configuration
Command
interface-number
interface-number
acl-number | priority