NEC Univerge sv8500 Manual page 3298

0. Config
(Continued) (Earlier than FW 2.0.0.0)
Parameter
1. DHCP Mode
1. Disable
2. Enable
2. IP Address
3. Default Gateway
4. Subnet Mask
5. DNS Address
6. Advanced Settings
1. LAN Port Settings
1. Speed&Duplex
1. Autonego
2. 100M Full
3. 100M Half
4. 10M Full
5. 10M Half
2. VLAN Mode
1. Disable
2. Enable
3. VLAN ID
4. VLAN Priority
2. PC Port Settings
1. Speed&Duplex
1. Autonego
2. 100M Full
3. 100M Half
4. 10M Full
5. 10M Half
2. VLAN Mode
1. Disable
2. Enable
3. Port VLAN ID
4. Port VLAN Priority
5. Port Available
0. Automatic
1. Disable
6. EAPOL Forwarding
1. Disable
2. Enable
3. CDP Mode
1. Disable
2. Enable
4. Type of Service
1. RTP
2. SIP
Description
Selects whether to use DHCP protocol.
DHCP is not used.
DHCP is used.
Sets DT700 Series terminal's IP address.
Sets default router's IP address.
Sets subnet mask.
Sets DNS server's IP address.
Sets network expanded data.
Sets LAN port.
Sets communication speed of Ether port.
Autonegotiation
100Mbps in full-duplex mode
100Mbps in half-duplex mode
10Mbps in full-duplex mode
10Mbps in half-duplex mode
Selects whether to use VLAN on terminal.
VLAN is not used.
VLAN is used.
Sets VLAN ID of terminal [0-4096].
Sets VLAN Priority of terminal [0-7].
Sets PC port.
Sets communication speed of PC port.
Autonegotiation
100Mbps in full-duplex mode
100Mbps in half-duplex mode
10Mbps in full-duplex mode
10Mbps in half-duplex mode
Selects whether to use port VLAN of PC port.
Port VLAN of PC port is not used.
Port VLAN of PC port is used.
Sets port VLAN ID of PC port [0-4096].
Sets port VLAN priority of PC port [0-7].
Selects whether to use PC port.
Sets Automatic for PC port.
PC port is not used.
Select whether to forward EAPOL packet from
PC port.
Not forward EAPOL packet from PC port.
Forwards EAPOL packet from PC port.
Selects whether to notify HUB of power
consuming information.
CDP is not used (Not send CDP to HUB).
CDP is used (Sends CDP to HUB).
Sets ToS value.
Sets ToS value for RTP in Hex.
Sets ToS value for SIP in Hex.
VOL.3-811
CHAPTER 4 CONFIGURATION SETUP
DT750
Default
Series
Enable X
0.0.0.0 X
0.0.0.0 X
0.0.0.0 X
0.0.0.0 X
- X
- X
Autonego X
Disable X
7 X
5 X
- X
Autonego X
Disable X
7 X
5 X
Automatic X
Disable X
Disable X
-
A0 X
C0
DT730 DT710
Series Series
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X
X X