NEC Univerge sv8500 Manual page 3307

Parameter
2. Addition
Directory Search
Note 3
Directory Add
Note 3
3. Prefix
4. Delete One
5. Delete All
This menu has the same function with "2. Directory (Not Earlier than FW 2.0.0.0 but Earlier Than FW
Note 2:
5.0.0.0)" → "2. Edit."
The following shows the operating procedure from Directory Search to Directory Add:
Note 3:
STEP 1: This Directory Search menu has the same function with "2. Directory (Not Earlier than FW 2.0.0.0 but
Earlier Than FW 5.0.0.0)"
alphanumeric order (see LCD-1).
STEP 2: Select the target data on the list, and then press the software key for "OK" to move on to LCD-2.
STEP 3: In the example below, from "2.Tel #2" to down on the list are vacant and new numbers can be added
to. Select "2.Tel #2" and press the software key for "OK" to move on to Category Set screen (LCD-3).
LCD-1
[Directory]
1.NEC ICHIRO
2.NEC TARO
3.NEC HANAKO
Back
Follow the sub menu "2. Directory Add"
* This is an example for DT730 Series (Standard LCD).
Description
Adds numbers to searched data.
Searches the Directory data to which you want to
add the number
Adds the number to the searched data on the
Directory
Adds a prefix to the number displayed on the LCD.
Deletes one history displayed on the LCD.
Deletes all the history of the corresponding
category (Missed, Outgoing, Incoming)
→
"1. Personal"
LCD-2
[Directory]
1.2000
2.Tel#1
3.Tel#2
OK
VOL.3-820
CHAPTER 4
→
"1. Search." On searching, data (name) are listed in
Back OK
→ "1. New" for the subsequent procedure.
CONFIGURATION SETUP
DT750 DT730
Default
Series Series
- X
- X
- X
- X
- X
- X
LCD-3
[Category]
1.Company
2.Mobile
3.Voice Mail
Back OK
X
X
X
X
X
X