NEC Univerge sv8500 Manual page 3254

G
STEP 35: The LCD displays [Download Menu] screen. Select "1. Download Files."
[Download Menu]
1.Download Files
2.Download Address
3.Protocol
STEP 36: On [Download Files] menu, select the download file type and then press the software key for "OK."
[Download Files]
1.Config
2.Certificate
3.Boot & Program
STEP 37: File name is displayed for each selected download file.
This is an example for selecting Boot & Program file.
[Boot & Program]
itlisipv.tgz
BK Cancel Exec
See Download file on page 758 for the default file name of each type.
Note:
STEP 38: When you want to change the download file name, perform this step.
[Ring Tone]
ringmusic.wav
BK Cancel Exec
See [How to Enter Characters on Configuration Menu] for the way to enter characters.
Note:
H
Exit
- Configuration file, select "1. Config"
- Boot & Program file, select "3. Boot & Program"
- Flash memory image file, select "4. Flash Memory Image"
- Voice file, select "6. Voice File"
Exit
- Translation data file, select "7. Language Pack"
Note 1: For firmware versions earlier than 4.0.0.0
(except for DT730G), displayed as "Translation Data."
Change the download file name
Not change the download file name, chack the file name and
press the software key for "Exec."
1. Press the software key for "BK" to delete the displayed file name.
2. Enter other name (up to 20 characters).
3. Press the software key for "Exec".
VOL.3-767
CHAPTER 4 CONFIGURATION SETUP
Note 1
Go to STEP 38
Go to STEP 39
Go to STEP 39