NEC Univerge sv8500 Manual page 3268

"SIP server" used here refers to the Telephony Server. The Telephony Server acts as SIP server where
Note:
DT700 Series terminal is registered.
When the assigned parameter cannot be displayed in one page, the LCD displays as follows.
Note 1:
User ID
xxxxxxxxxxxxx
Up Down Prev >>
">>"
User ID
xxxx
Up Down Prev |<
About IP address of SIP server (Telephony Server), refer to "Registration Destination of IP Devices/Sta-
Note 2:
tions" in INTRODUCTION of Installation Manual.
"Connecting Server(*)" means the system that supports Location Diversity [L-55]. "(*)" is displayed
Note 3:
when registration is completed successfully by the SIP server address specified on the address list. This
mark is not displayed during registration is in progress.
"(DHCP)" is displayed when the parameter is obtained from DHCP server.
Note 4:
1st Server(DHCP)
Up Down Prev
SIP server's address assigned either by DHCP server option 162 or by the configuration setting is dis-
Note 5:
played for 1st Server ~ 4th Server parameters though, when the registration process is completed success-
fully by the SIP server's address specified by the address list, "IP Address is Invalid!" is displayed for 1st
Server ~ 4th Server parameters recognizing the Location Diversity connection.
page number
P1
"|<"
P2
the last page
xxx.xxx.xxx.xxx
CHAPTER 4
VOL.3-781
CONFIGURATION SETUP