D
STEP 20: The terminal starts downloading. "Downloading..." flashes on the LCD.
Downloading...
STEP 21: The LCD displays the message below. Press the software key for "Exit" to restart the terminal.
Download Complete!
Press Exit to Reset
STEP 22: DT700 Series terminal restarts reading out the downloaded program.
END
The following table lists the points to be checked. Try downloading again.
Note:
Target download file is not put in the directory
specified by FTP/TFTP server.
File name differs between the file on the FTP/
TFTP server and the file you try to download.
The IP address of FTP/TFTP server assigned on
the configuration setting is wrong.
FTP/TFTP server or the network device (e.g.
HUB) between the server and the terminal is not
turned on.
LAN cable disconnection.
When the LCD returns "Download Failed" messages even after some retry, the memory of the terminal
may be damaged. Contact a maintenance personnel.
Exit
Initializing
CAUSE
CHAPTER 4
Saving...
[
]
Note: Do not power off the terminal while the LCD
is displaying "Saving...". It may cause trouble in
DT700 Series starting up.
COUNTERMEASURES
Place the download file on the directory where
FTP/TFTP server specifies.
Assign the same file name on the server and on
the terminal.
Enter correct IP address of FTP/TFTP server.
Turn the power on for the devices.
Connect LAN cable to the terminal and FTP/
TFTP server.
VOL.3-799
CONFIGURATION SETUP