[5] Terminal Settings
STEP 1: When "5. Terminal Settings" is selected, the LCD displays the following.
Hardware Version
x.x.x.x (yyyyyy)
Up Down Prev
STEP 2: Switch the page to display other parameters by pressing the software key for "Up" and "Down."
•
Hardware Version - - - - - -Hardware version of terminal, destination of the unit attached (FW
•
MAC Address - - - - - - - -MAC address of terminal
•
Firmware Version - - - - - -Firmware version of terminal
•
Bottom Option - - - - - - - -ADA Unit version attached to terminal
•
Side Option1 - - - - - - - - -Side option name of terminal
•
Side Option2 - - - - - - - - -Side option name of terminal
*See Parameters in Terminal Settings for the page switching order by Up and Down key.
STEP 3: Pressing the software key "Prev" returns the LCD to System Information menu.
5.Terminal Information
1.Network Settings
2.SIP Settings
Up Down Prev
END
The destination information of the unit attached "(yyyyyy)"
Note:
is displayed from FW 4.0.0.0 (For DT730G, FW 1.0.0.0 or
later).
4.0.0.0. or later (For DT730G, FW 1.0.0.0 or later))
Exit
VOL.3-786
CHAPTER 4
CONFIGURATION SETUP