NEC Univerge sv8500 Manual page 3256

In the case of download failure, the LCD displays the message below.
Note:
Download Failed!
The following table lists the points to be checked. Try downloading again.
Target download file is not put in the directory
specified by FTP/TFTP server.
File name differs between the file on the FTP/
TFTP server and the file you try to download.
The IP address of FTP/TFTP server assigned on
the configuration setting is wrong.
FTP/TFTP server or the network device (e.g.
HUB) between the server and the terminal is not
turned on.
LAN cable disconnection.
When the LCD responses "Download Failed" message again even after some retry, the memory of the ter-
minal may be damaged. Contact a maintenance personnel.
[2] Configuration Setting by Web Programming
STEP 1: Prepare download file on FTP/TFTP server. (See STEP 1 in [1] Configuration Setting on Terminal.)
STEP 2: Select [Maintenance]
[Config] for Configuration file download
[Boot & Program] for Boot & Program file download
[Flash Memory Image] for Flash memory image file download
[Voice File] for voice file download
[Language Pack] for translation data file download Note 1
Web Programming does not support the downloading of Music-on-Hold, Ringing Tone, and Terminal
Note:
Phonebook files. Refer to [1] Configuration Setting on Terminal for these types of file downloading.
For firmware versions earlier than 4.0.0.0 (except for DT730G), displayed as "Translation Data."
Note 1:
Exit
CAUSE
→ [Download Menu]
VOL.3-769
CHAPTER 4
COUNTERMEASURES
Place the download file on the directory where
FTP/TFTP server specifies.
Assign the same file name on the server and on
the terminal.
Enter correct IP address of FTP/TFTP server.
Turn the power on for the devices.
Connect LAN cable to the terminal and FTP/
TFTP server.
→ [Download Files].
CONFIGURATION SETUP