14.3.12 Configuring Access Lists
ROUTER: These commands can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to
Purpose
To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and source IP address restrictions.
Commands
The commands used to review and configure security access lists are listed below and described in
the associated section as shown:
•
show access-lists
•
access-list (standard)
•
access-list (extended)
•
ip access-group
(Section
(Section
14.3.12.1)
(Section
14.3.12.4)
(Section
14.3.12.3)
14.3.12.4)
Security Configuration Command Set
Matrix NSA Series Configuration Guide
Configuring Access Lists
Section
2.3.3.
14-159