Set Pwa Portcontrol - Enterasys N Standalone (NSA) Series Configuration Manual

14.3.6.20 set pwa portcontrol

Use this command to set the PWA port control mode.
set pwa portcontrol {auto | forceauthorized | forceunauthorized |
promiscuousauto} [port-string]
Syntax Description
auto
forceauthorized
forceunauthorized
promiscuousauto
port-string
Command Defaults
If port-string is not specified, control mode will be set for all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Configuring Port Web Authentication (PWA)
Sets the port to auto mode. In this mode, the port is
filtering traffic. Login/Logout screens are available, as is
the PWA IP. Spoofing (ARP, DNS, WINS and DHCP)
will respond to requests. If a default policy exists on the
port, it will be ignored in the unauthenticated state.
NOTE: In order for PWA enhanced mode to
operate, port control mode must be set to auto.
Sets the port to force authorized mode. In this mode, the
port is transmitting and receiving traffic. The Web server
Login/Logout screens are inaccessible, as is the PWA IP.
Spoofing (ARP, DNS, WINS or DHCP) will not respond
in this mode.
Sets the port to force unauthorized mode. In this mode, the
port is essentially disabled.
Sets the port to promiscuous auto mode. In this mode, no
filtering is done unless a default policy applies to the port.
(Optional) Sets the control mode on specific port(s). For a
detailed description of possible port-string values, refer
to Section 4.1.1.
Matrix NSA Series Configuration Guide
Security Configuration Command Set
14-75