Enterasys N Standalone (NSA) Series Configuration Manual page 1209

14.3.5.5 clear dot1x auth-config
Use this command to reset 802.1X authentication parameters to default values on one or more ports.
clear dot1x auth-config [authcontrolled-portcontrol] [keytxenabled] [maxreq]
[quietperiod] [reauthenabled] [reauthperiod] [servertimeout] [supptimeout]
[txperiod] [port-string]
Syntax Description
authcontrolled-
portcontrol
keytxenabled
maxreq
quietperiod
reauthenabled
reauthperiod
servertimeout
supptimeout
txperiod
port-string
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
•
(Optional) Resets the 802.1X port control mode to auto.
(Optional) Resets the 802.1X key transmission state to
disabled (false).
(Optional) Resets the maximum requests value to 2.
(Optional) Resets the quiet period value to 60 seconds.
(Optional) Resets the reauthentication control state to
disabled (false).
(Optional) Resets the reauthentication period value to 3600
seconds.
(Optional) Resets the server timeout value to 30 seconds.
(Optional) Resets the authentication supplicant timeout
value to 30 seconds.
(Optional) Resets the transmission period value to 30
seconds.
(Optional) Resets settings on specific port(s). For a
detailed description of possible port-string values, refer to
Section
If no parameters are specified, all authentication parameters will be reset.
Security Configuration Command Set
4.1.1.
Matrix NSA Series Configuration Guide
Configuring 802.1X Authentication
14-49