Set Next Hop - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring Policy-Based Routing

14.3.13.4 set next hop

Use this command to set one or more next hop IP address for packets matching an extended access
list in a configured route map. Up to five next hops can be specified.
set next hop {next-hop1}[next-hop2....next-hop5]
Syntax Description
next-hop
Command Syntax of the "no" Form
The "no" form of this command deletes next hop IP address(es):
no set next hop {next-hop1}[next-hop2....next-hop5]
Command Type
Router command.
Command Mode
Policy-based routing configuration: Matrix>Router1(config-route-map-pbr)#
Command Defaults
None.
Example
This example shows how to set IP address 10.2.3.4 as the next hop for packets matching ACL 1:
Matrix>Router1(config)#route-map 101 permit 20
Matrix>Router1(config-route-map-pbr)#match ip address 1
Matrix>Router1(config-route-map-pbr)#set next-hop 10.2.3.4
14-176 Matrix NSA Series Configuration Guide
Specifies a next hop IP address(es). Up to five can be
configured.