Enterasys N Standalone (NSA) Series Configuration Manual page 1273

14.3.8.11 set cep detection-id protocol
Use this command to specify an IP protocol type for H.323, Siemens, or SIP convergence end points
detection. If an IP address is not set for a phone detection group as described in
this will configure detection on UDP and/or TCP ports using a port range defined with the set cep
detection-id porthigh | portlow command as described in
set cep detection-id id protocol {tcp | udp | both | none}
NOTE: This command applies only to Siemens, H.323, and SIP phone detection. Cisco
detection uses CiscoDP as its discovery method.
Syntax Description
id
tcp | udp | both |
none
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable both TCP and UDP convergence end points detection for CEP
:
detection group 1
Matrix>set cep detection-id 1 protocol both
Configuring Convergence End Points (CEP) Phone Detection
Specifies a CEP configuration group ID. This group must
be created and enabled using the set cep detection-id
command as described in
1 - 2147483647.
Sets the CEP IP protocol type to be used for detection as:
•
TCP
•
UDP
•
Both UDP and TCP
•
None
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Section 14.3.8.12.
Section 14.3.8.8. Valid values are
Section 14.3.8.10,
14-113