Set Flowlimit Notification - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring Flow Setup Throttling (FST)

14.3.15.11 set flowlimit notification

Use this command to enable or disable flow limit notification, or to set a notification interval. When
enabled, this allows ports configured with a "trap" action to send an SNMP trap message when a
specified flow limit is reached. For information on using the set flowlimit limit command to
configure a trap action on a port, refer to
set flowlimit notification {disable | enable | interval}
Syntax Description
disable | enable
interval
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to enable the flow limit notification function:
Matrix(rw)->set flowlimit notification enable
14-204 Matrix NSA Series Configuration Guide
Section 14.3.15.3.
Disables or enables SNMP notification.
Specifies a notification interval (in seconds) for SNMP trap
messages. Valid values are 0 - 4294967295.