Enterasys N Standalone (NSA) Series Configuration Manual page 1321

14.3.12.2 access-list (standard)
Use this command to define a standard IP access list by number when operating in router mode.
Restrictions defined by an access list are applied by using the ip access-group command
(Section 14.3.12.4).
access-list access-list-number [insert | replace entry] | [log 1-5000 | all] [move
destination source1 [source2]] {deny | permit} source [source-wildcard]
To insert or replace an ACL entry:
access-list access-list-number insert | replace entry
To move entries within an ACL:
access-list access-list-number move destination source1 [source2]
NOTE: Valid access-list-numbers for standard ACLs are 1 to 99. For extended ACLs,
valid values are 100 to 199.
Syntax Description
access-list-
number
insert | replace
entry
log 1-5000 | all
move destination
source1 source2
deny | permit
Specifies a standard access list number. Valid values are
from 1 to 99.
(Optional) Inserts this new entry before a specified entry in
an existing ACL, or replaces a specified entry with this new
entry.
Enable syslog for ACL entry hits. Enable syslog for
sequential number of ACL entry or for all ACL entries
(Optional) Moves a sequence of access list entries before
another entry. Destination is the number of the existing
entry before which this new entry will be moved. Source1 is
a single entry number or the first entry number in the range
to be moved. Source2 (optional) is the last entry number in
the range to be moved. If not specified, only the source1
entry will be moved.
Denies or permits access if specified conditions are met.
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring Access Lists
14-161