General Configuration Command Set; Setting The Login Password; Set Password - Enterasys Matrix E1 1G694-13 Configuration Manual

Startup and General Configuration

Setting the Login Password

3.2

GENERAL CONFIGURATION COMMAND SET

3.2.1 Setting the Login Password
Purpose
To change the login password on the CLI.
Command
The command needed to set the login password is listed below and described in the associated
section as shown.

• set password

(Section
3.2.1.1 set password
Use this command to set the login password on the CLI.
set password {rw | ro}
Syntax Description
rw | ro
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to set an initial Read-Write password:
Matrix>set password rw
Enter old password: ********
Enter new password: ********
Retype new password: ********
Password changed.
3-10 Matrix E1 Series (1G694-13) Configuration Guide
3.2.1.1)
Sets the password to Read-Write or Read-Only.