Match Ip Address - Enterasys N Standalone (NSA) Series Configuration Manual

14.3.13.3 match ip address

Use this command to match a packet source IP address against a PBR access list. Up to 5 access
lists can be matched.
match ip address access-list-number
Syntax Description
ip address
access-list-number
Command Syntax of the "no" Form
The "no" form of this command removes the match between an access list and this
route map:
no match ip address access-list-number
Command Type
Router command.
Command Modes
Policy-based routing configuration: Matrix>Router1(config-route-map-pbr)#
Command Defaults
None.
Example
This example shows how to match a packet source IP address to access list 1:
Matrix>Router1(config)#route-map 101
Matrix>Router1(config-route-map-pbr)#match ip address 1
Matches packet source IP addresses to the specified access
list.
Specifies an access list to match to the packet source IP
address. Valid values are 1 - 199.
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring Policy-Based Routing
14-175