Clear Multiauth Session-Timeout - Enterasys N Standalone (NSA) Series Configuration Manual

14.3.10.16 clear multiauth session-timeout

Use this command to clear multiple authentication session-timeout values, for an active session,
back to the default values.
clear multiauth session-timeout [cep | dot1x | mac | pwa]
Syntax Description
cep | dot1x | mac |
pwa
Command Defaults
If no authentication type is specified, the session timeout value is returned to 300
seconds for all authentication types.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to clear the session-timeout values, for an active session, for cep and mac
authentication types, to the default value of 0 seconds:
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
This example shows how to clear the session-timeout values, for an active session, for all
authentication types, to the default value of 0 seconds:
Matrix(rw)->set multiauth idle-timeout
(Optional) Specifies authentication type:
•
cep — Enterasys Convergence End Point Authentication
•
dot1x— IEEE 802.1X Port-Based Network Access
Control
•
mac — Enterasys MAC Authentication
•
pwa — Enterasys Port Web Authentication
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring Multiple Authentication
14-151