Set Flowlimit Port - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring Flow Setup Throttling (FST)

14.3.15.8 set flowlimit port

Use this command to:
•
enable or disable flow limiting on one or more port(s),
•
assign a flow limiting user classification to one or more port(s). Once a classification is assigned,
these ports will be subject to the flow limit configured (with the set flowlimit limit command as
described in Section
command as described in
•
Enable an interface previously disabled by a flow limiting action.
set flowlimit port {enable | disable} | class {userport | serverport |
aggregateduser | interswitchlink | unspecified} | status {operational}
[port-string]
Syntax Description
enable | disable
class userport |
serverport |
aggregateduser |
interswitchlink |
unspecified
status operational
port-string
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
If port-string is not specified, settings will apply to all ports.
14-200 Matrix NSA Series Configuration Guide
14.3.15.3) and the action configured (with the set flowlimit action
Section 14.3.15.5).
Enables or disables flow limiting on specified ports.
Assigns a user classification type to the port(s) as:
•
user port
•
server port
•
aggregation port
•
interswitch link
•
unspecified port
Enables an interface previously disabled by a flow limiting
action.
(Optional) Specifies port(s) on which to configure flow
limiting parameters.