Honda ACCORD HYBRID 2005 Service Manual page 90

Engine Assembly
E n g i n e I n s t a l l a t i o n ( c o n t ' d )
2. Position the engine/transmission assembly under
the vehicle, and be sure that they are properly
positioned. Carefully lower the vehicle until the
engine and t r a n s m i s s i o n are properly positioned in
the engine c o m p a r t m e n t . Lift and support the
engine w i t h engine hanger (A) and engine balancer
bar (B). Attach the f r o n t a r m (C) to the front cylinder
head w i t h a spacer (D) and the connector bracket
bolt (10 x 1.25 m m ) (E). Attach the rear arm (F)to
the rear cylinder head w i t h the harness c l a m p
bracket bolt (8 x 1.25 m m ) (G). Lift the engine into
position in the vehicle.
NOTE: Reinstall all m o u n t i n g bolts/support nuts in
the sequences given. Failure to f o l l o w this may
cause excessive noise and v i b r a t i o n , and reduce
bushing life.
A B
AAR-T-12566 VSB02C000019
3. Raise the vehicle on the hoist to full height.
4. Attach the front s u b f r a m e adapter to the subframe
by hanging the belt (A) over the front of the
subframe (B), then secure the belt w i t h the lock pin
(C) and tighten the w i n g nut (D). Raise the subframe
up to the body w i t h a jack.
B
5. Loosely install the four s u b f r a m e m o u n t i n g bolts
(A) and four 12 x 1.25 m m bolts (B), (C) w i t h the
stiffeners.
3 4 I M I T I
(5.5 kgf-m, 40 Ibf-ft)
5-12