Table 1-61 Error Code C8-2 Paper Jam Clear Areas A,B - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RAP 1-33
Error Code C8-2
There is problem with the Tray 2 Take Away Sensor.
Logic Control on the Print Engine Controller Board sensed the Tray 2 Take Away
Sensor was on while the printer was in standby.

Table 1-61 Error Code C8-2 Paper Jam Clear Areas A,B

Step Actions and Questions
1 Tray 2 TAKE AWAY SENSOR INSPECTION
Inspect the Tray 2 Take Away Sensor for contamination or
paper scraps that may have actuated the sensor.
Is the Sensor clean and free of paper scraps?
2 Tray 2 TAKE AWAY SENSOR TEST
1. Enter Diagnostics Mode.
2. From the Main Menu, select Comp Input Test / IOT
Unit / T/A Roll2 Sensor to test Take-Away Roller 2
Sensor.
3. Press [4] to start, [0] to stop.
4. Open the Left Upper Cover (A).
5. Insert, then remove, a sheet of paper into the Tray 2
Take Away Sensor.
Does the Control Panel display "with paper"
when you insert the paper into the Tray 2 Take
Away Sensor, and is "without paper" displayed
when you remove the paper?
PRINT ENGINE CONTROLLER BOARD
3
REPLACEMENT
Replace the Print Engine Controller Board (RRP 1-72).
Does the error code appear?
4 The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one at
a time, until you isolate and solve the problem.
Wiring and connectors linking the components


Input/Output Board (RRP 1-70).


1-86 DocuPrint N4525 Network Laser Printer - Service Guide
Paper Jam
Clear Areas A,B
Yes
Go to step 2
Go to step 3
Go to step 4
No
Clean or clear
paper scraps
from the
Sensor
Replace the
Tray 2 Take
Away Sensor
Problem
solved