Table 29 Error Code E1-1: Paper Jam Tray To Registration Troubleshooting Procedure; Rap 50 - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 9 Error Code E1-1:
There is a paper jam between the Paper Tray / Paper Handler Assembly and the
Registration Sensor.
Table 29 Error Code E1-1: Paper Jam Tray to Registration
Troubleshooting Procedure
Step Actions and Questions
1 REGISTRATION SENSOR ACTUATOR
INSPECTION
Inspect the Registration Sensor Actuator.
Is there foreign material blocking the
Registration Sensor Actuator?
2 REGISTRATION SENSOR TEST
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Sensor
Input / press [4] to start test, [0] to stop.
3. Manually actuate the Registration Sensor Actuator
while observing the LCD.
Does the LCD counter increment each time you
actuate the Registration Sensor Actuator?
REGISTRATION CLUTCH TEST
3
1. From the Main Menu, select Component Test / Reg
Clutch / press [4] to test.
2. Listen for the Registration Clutch to actuate and
deactuate.
Did the Registration Clutch actuate & deactuate?
4 SUSPECT COMPONENTS
The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one
at a time, until you isolate and solve the problem.
Wiring and connectors linking the components
I
Print Engine Controller Board [RRP 8.5,
page 310].
60
Paper Jam
Open Top Cover
Yes
Remove
foreign
material.
Replace the
Print Engine
Controller
Board
(RRP 8.5,
page
Replace the
Print Engine
Controller
Board
(RRP 8.5,
page
Phaser 5400 Laser Printer Service Guide
No
Go to
Step 2.
Go to

RAP 50,

page 135.
310].
Go to
RAP 39,
page 112.
310].