Error Code - Xerox Wide Format 6705 System User Manual

1.10.4

Error Code

An error code is displayed if calibration has failed with an error.
Refer to the error codes in the following table to resolve problems.
Error Code
062-702 The <Stop> button was pressed while the

calibration chart was still being scanned.
A paper jam occurred.

062-714 The calibration chart is loaded wrong side up.

The calibration chart is loaded in an incorrect

orientation.
The calibration chart is torn.

062-713 The position of the document guide is being

062-725
shifted to the right.
The right edge of the calibration chart is not

aligned with the document guide.
The calibration chart was fed skewed.

The calibration chart was not printed in its

entirety or is torn.
062-735 The calibration chart is not being fed at the

constant speed.
Auto Adjust failed.
*
Others

* Any other codes between 062-701 and 062-754
Cause Remedy
Load the calibration chart again.

Check that the calibration chart is free of dirt and is

not torn, and load it face down on the document
table.
Check whether the document guide is at the correct

position.
Check that the calibration chart is free of dirt and is

not torn, and load it face down on the document
table.
Make sure that you do not apply external force on

or pull the calibration chart while it is being
scanned.
Check the remedies above again, and load the

calibration chart.
If the trouble persists even after performing the

suggested actions, contact your local Xerox repre-
sentative.
1.10 Calibrating the Scan Sensor Gap
1
61