Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
For a general port, the PVID can be an unauthenticated VLAN (although only
tagged packets are accepted in the unauthorized state).
Example
The following example enables unauthorized devices access to VLAN 5.
Console(config)#
Console(config-if)#
dot1x host-mode
Use the dot1x host-mode Interface Configuration mode command to allow a
single host (client) or multiple hosts on an IEEE 802.1x-authorized port. Use
the no form of this command to return to the default setting.
Syntax
dot1x host-mode
Parameters
multi-host—Enable multiple-hosts mode.
•
•
single-host—Enable single-hosts mode.
•
multi-sessions—Enable multiple-sessions mode.
Default
Default mode is multi-host.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
In multiple hosts mode only one of the attached hosts must be successfully
authorized for all hosts to be granted network access. If the port becomes
unauthorized, all attached clients are denied access to the network.
In multiple sessions mode each host must be successfully authorized in order
to grant network access. Please note that packets are NOT encrypted, and
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\802.1X.fm
interface vlan
dot1x auth-not-req
{multi-host | single-host | multi-sessions}
5
802.1x Commands
313
Advertisement
Table of Contents
