Figure 7.6 [Modify Fc Port Mode] Screen - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
7.2 Basic Setup
5
5-1
5-2
6
Modify the FC Port Mode. (Only for ETERNUS DX90)
Change the port mode of the Fibre Channel port (Channel Adapter (CA) or Remote
Adapter (RA)).
Set the "Port Mode(After)" to the appropriate port mode, and click the [Next >] button.
•
IMPORTANT
•
•
Figure 7.6 [Modify FC Port Mode] screen
A confirmation screen appears.
Click the [OK] button.
The port mode is set, and the [Port Parameter Settings] screen appears.
Set Port Parameters.
Set the connecting information for the port.
Setting screens will vary depending on the ETERNUS DX60/DX80/DX90 model.
When using the Host Affinity functions, make sure to "Enable" the
IMPORTANT
Host Affinity setting of the port.
Refer to
Host Affinity functions.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Select "CA" when using the port to connect to the server.
Select "RA" when using the port for REC.
If the port mode is changed from "CA" to "RA", the LUN
mapping information for the target CA port will be deleted.
If the port mode is changed from "RA" to "CA", the Advanced
Copy path information specified for the target FC port will be
deleted.
"1.3.7 Security Functions" (page 46)
145
for details about the
P3AM-3042-08ENZ0