Operation; Punch Registration Control (Available Only When Pk Is Installed) - Develop ineo+ 6500 Service Manual

Theory of Operation Ver1.0 Sep.2006
4.3

Operation

4.3.1

Punch registration control (available only when PK is installed)

The FNS conveyance motor (M1) turns OFF temporarily to stop conveyance of paper when the specified time
has passed since paper exit sensor (PS37) detected the leading edge of the paper. Thus the paper is pressed
against the entrance roller forming a loop to correct the bend. When the specified time has passed, M1 turns
ON to restart conveying the paper.The above operation is not performed when conveying a large paper (220
mm and longer in the sub scan direction) and in the non-punchingmode.
When punching the paper conveyed from PI, the loop is formed on the PI's side. For details, refer to PI-502 ser-
vice manual.
[1] Main body
[2] Entrance roller
[4]
[1]
[2]
[3]
[3] Loop
[4] PK (option)
4. TRANSFER SECTION
a04dt2c002ca
13