Develop ineo+ 6500 Service Manual page 475

7. STAPLER SECTION
B. Staple control
(1) Stapling
After completing the alignment operation of the alignment plate, the stapler motors /Rr (M9) and /Fr (M14) per-
form the stapling operation. After a specified period of time, the clincher motors /Rr (M10) and /Fr (M15) bend
the staples.
The stapling operation is completed when the clincher motor home sensors /Rr (PS32) and /Fr (PS33) and the
stapler motor home sensors /Rr (PS30) and /Fr (PS31) detect the home position and turn ON.
(2) Clogged staple detection
During the stapling operation, it is determined that the staple has been clogged and the stapler motors /Rr (M9)
and /Fr (M14) and the clincher motors /Rr (M10) and /Fr (M15) rotate in the reverse direction to replace the sta-
plers and the clinchers to the home positions if the stapler motor home sensors /Rr (PS30) and /Fr (PS31) and
the clincher motor home sensors /Rr (PS32) and /Fr (PS33) do not turn ON after a specified period of time since
they turn OFF.
(3) Cartridge detection
The cartridge set switches /Rr (SW1) and /Fr (SW3) detect the presence of a cartridge or the incorrect setting of
a cartridge.
When no cartridge is set or it is set incorrectly, the main body displays the error message on its display panel.
(4) Staple detection control
When the staples run out, the staple empty switches /Rr (SW2) and /Fr (SW4) turn ON and the main body dis-
plays the error message on its display panel.
50
Theory of Operation Ver1.0 Sep.2006