Develop ineo+ 6500 Service Manual page 641

9. TRIMMER SECTION
B. Control
In trimming mode, the trimmer paddle motor (M33) starts forward/reverse rotation after paper clipping is oper-
ated by the bundle clip motor (M11), and then the M33 motor stops when the trimming JOB is finished.
If the trimming amount value is set in the "Trimming adjustment" in service mode, the forward/reverse rotation of
motor is controlled by the trimming amount that is added the adjusted value. (Edges of standard sized paper is
trimmed by 2mm even when the adjutment value is set to 0.)
120
1
Theory of Operation Ver2.0 Sep.2006