Develop ineo+ 6500 Service Manual page 461

6. STACKER SECTION
(3) Tri-folding mode
Transmitting the FNS signal from the main body [1], the saddle stitching stopper motor (M18) rotates [2] to move
down the saddle stitching stopper to the stopping position in accordance with the paper size.
After completing the alignment operation of the last paper [3], M18 rotates [4] to move down the saddle stitching
stopper to the 1st folding position in the tri-folding.
After completing the folding operation, when the folding paper exit sensor (PS25) detects the trailing edge of the
paper bundle, M18 rotates [5] to move up the saddle stitching stopper to the alignment position in accordance
with the paper size and stand by for the paper of the subsequent copy.
Alignment motor /Up (M5)
Alignment motor /Lw (M16)
Saddle stitching stopper home sensor (PS23)
Saddle stitching stop-
per motor (M18)
Folding paper exit sensor (PS25)
[1] FNS start signal turned ON
[2] Moving to the alignment position for the
paper size
[3] Last paper of the copy aligned
(4) Flat-stapling mode
The saddle stitching stopper motor (M18) does not operate in the flat-stapling mode.
36
UP
DOWN
[1] [2]
Theory of Operation Ver1.0 Sep.2006
[3]
[4]
[4] Moving to the 1st folding position
[5] Moving to the alignment position for the
subsequent copy
[5]
15jmt2c007na