Develop ineo+ 6500 Service Manual page 279

4. CONVEYANCE SECTION
A. Decurler /Up control
• When the upward paper curl straightening ON in the service mode and Adjustment Menu-Finisher Adjust-
ment setting, a start-printing signal is sent form the main body and the decurler gate solenoid /1 (SD2)
starts operating. Then it switches the direction of paper conveyance path toward the decurler /Up.
• The paper conveyance path is switched to the normal path when the SD2 is OFF. When the SD2 is ON, the
path is switched toward the decurler /Up.
• SD2 stop the operation after predetermined time has passed since the paper exit sensor (PS3) detected
the trailing edge of the last paper.
B. Decurler /Lw control
• When the downward paper curl straightening ON in the service mode setting, a start-printing signal is sent
form the main body and the decurler gate solenoid /2 (SD3) starts operating. Then it switches the direction
of paper conveyance path toward the decurler /Lw.
• The paper conveyance path is switched to the normal path when the SD3 is OFF. When the SD3 is ON, the
path is switched toward the decurler /Lw.
• SD2 stop the operation after predetermined time has passed since the paper exit sensor (PS3) detected
the trailing edge of the last paper.
14
Theory of Operation Ver1.0 Sep.2006