Develop ineo+ 6500 Service Manual page 411

7. STAPLER SECTION
C. Staple cut/clinch control
When the eccentric cam rotates from 180° to 270°, the pin [1] provided on the inside drives the staple cut/clinch
arm [2] in the arrow-marked direction.
At the start of rotation, the lever operation of the staple cut/clinch arm [2] rotates the coupling metal fitting [3] to
pull the pin [4] in the arrow-marked direction and the staple [7] inserted into the round hole [6] of the staple cut
blade [5] is cut. Staple scraps that have been cut drop into the duct to be collected in the staple scraps box.
With the further rotation of the eccentric cam, the tip of the presser metal fitting [8] that is interlocked with the
staple cut/clinch arm [2] pushes down the clinch metal fitting [9] to clinch the staple [7] that has been cut. When
the eccentric cam rotates up to 270°, the clinch operation is completed. After completion of clinching, the
eccentric cam rotates to the home position to complete a series of operations.
[8]
[9]
[6]
[1] Pin
[2] Staple cut/clinch arm
[3] Coupling metal fitting
[4] Pin
[5] Staple cut blade
32
[7]
[5]
[7]
[5]
Theory of Operation Ver2.0 Sep.2006
[8]
[9]
[6] Round hole
[7] Staple
[8] Presser metal fitting
[9] Clinch metal fitting
[3]
[4]
[1]
[2]
fs503to2022c